threaded rod type으로 지지된 2단 Straight

threaded rod type으로 지지된 2단 Straight구간 30m미만 지점에서설치 시작,
이후 30m간격으로 설치,
말단은 30m미만이면설치하지 않는다.
(단, W750이상 1단 Tray straight 구간은그림과 같이말단 30m 이하에 보강지지대를 설치하여야 한다. 2단 초과설치시 15m마다 설치한다.)
으로 지지된
2단

Kết quả (Anh) 1:

Threaded rod type 2 support less than starting an installation from the point where the only Straight sections 30m,30m intervals after installation, If you do not install the extremity is less than 30m.(However, more than 750 W 1 only Tray straight section as shown in the following 30m install the reinforcement braces on the extremities shall be installed per the installation: only excess 15m. 2.)Support to theTwo-stage

Kết quả (Anh) 2:

threaded rod type with two start installation from the Straight period less than 30m point not to,
after a 30m interval installation,
the terminal does not install less than 30m.
(However, W750 over 1 Tray straight section is below the terminal 30m, as shown in Figure to be fitted with reinforced supports. install every 15m when installing more than two)
with the support
2

Kết quả (Anh) 3:

threaded rod type to a second section of the Straight thirty m only here to start the installation.after every thirty m setat the end of the thirty m less is not installed.(however, a section of more than W750 Tray straight picture and the thirty m below the equipment, maintenance support. a second device are mounted over each 15m).with the support of thethe second stage.